Replace a Window Controller in a Subaru Outback

My drivers side window would not go up, thats no good. So I had to replace the window controller.

Parts
So you'll need a PP-TD20 window controller unit.

Tools:
Phillips head screw driver
Panel Remover
Multimeter

There are only two screws in the door panels.
They are both below little plastic covers. One on the door release , and one below the handle.

Remove the tweeter covers, they just pop off.

Pop the panel pry tool in the door and pop the panel off. You can use a screw driver, but then you might break the little tabs off.

So my window would not go up... but it woul go down. So There is a green plug on the door, open it up and test out the behaviour. Since I got 0 volts with the meter when I pushed the switch up, but -12 when I pushed it down I figured it was the relay in the switch. Of course I had to order the prart, but in the mean time I used some alligator clips to reverse the switch and make the window go back up.

Unplug the switches.

remove the plasic face plate covering the switch.

unscrew the switch.

plug in your switch, make sure it works. if it does reverse the steps you are done.