Remote Control Lock

Hi,

Welcome to Creativity Buzz.

Here You can make wireless remote control door lock using Arduino Uno.

For more Arduino Projects visit Creativitybuzz

You need this materials for making this lock.
1) Arduino Uno

2) 4 Channel wireless switch

3) 100 RPM DC motor

4) Syringe

5) Nut and Bolt 2 inch lenght

6) M-seal

7) Wooden Block

8) Battery and wire

9) Stopper

It is awesome DIY PROJECT using DC motor and battery.

You need this materials for making this lock.

1) 4 Channel wireless switch

2) Stopper

3) 100 RPM DC motor

4) Syringe

5) Nut and Bolt 2 inch lenght

6) M-seal

7) Wooden Block

8) Battery and wire

Take one 12 X 14 CM Wooden Block and Marking 4 Holes.

Drill 4 Holes using Drill Machine On this Marking Point.

Make Sure Holes are not Passing through Other side.

Then tighten screw through stopper.

Make one hole using Drill Machine and place wireless reciver on wooden plate.

Then tight screw using screw driver.

Take some M-seal and Mix properly.

Then place this M-seal Mixer on nut and stick with stopper handle.

Wait for 3 hours for perfectly stick with stopper.

Take 2 Inch Bolt and Pass through out the nut.

First of all Take one syringe cap and cut 1 CM Portion using cutter.

Then take 100 RPM DC motor and connect with bolt using syringe cap.

Take Glue Gun and spread glue on wooden plate as per picture.

Then stick DC motor on this.

Try this model is working properly using direct wiring.

Wiring DC motor and Battery Connectors as per wiring diagram.

Pacing circuit using Cap of Box.

Connect two 9 volt battery to connector.

Try this wireless remote control locking system from 5 meter distance and place with doors.