RC Boat Made Out of Polyester

by Maxime1234 in Circuits > Remote Control

51502 Views, 14 Favorites, 0 Comments

RC Boat Made Out of Polyester

~IMG_2300.jpg
In this DIY, I will show you how to make an RC boat out of polyester, starting with a model of wood. Because there are to many photo's (250+), I' ve made 5 clips with the most important photo's in it.

There are four big steps:

Making the model
Making the mould
Making the boat in polyester
Finishing the boat

I am from Belgium, so please excuse me if I make any language mistakes.

In the next clip you can see the boat in action.

Part 1 - the Model in Wood

IMG_2074.JPG
IMG_2075.JPG
IMG_2076.JPG
IMG_2078.JPG
IMG_2081.JPG
~IMG_2084.jpg
~IMG_2085.jpg
~IMG_2086.jpg
~IMG_2089.jpg
~IMG_2094.jpg
~IMG_2102.jpg
~IMG_2107.jpg
~IMG_2110.jpg
~IMG_2115.jpg
~IMG_2116.jpg
In this part, I will show you how to make the model of wood. You can find many plans on the internet.

Part 2 - Making the Mould.

~Afb040.jpg
~Afb071.jpg
~Afb041.jpg
~Afb044.jpg
~Afb049.jpg
~Afb051.jpg
~Afb053.jpg
~Afb056.jpg
~Afb057.jpg
~Afb065.jpg
~Afb066.jpg
~Afb067.jpg
~Afb064.jpg
In this video, I will show how to make a mould with plaste. Later on, I will use this mould to make the polyester boat.

Part 3 - Making the Polyester Boat

IMG_2235.JPG
Afb120.jpg
In this step, you will see how to make the boat in polyester. You can also use epoxy. Because there are to many photo's in this step, I've placed them in the video below.

Part 4 - Setting Up the Inside of the Boat

Afb133.jpg
Afb144.jpg
We can now start with the inner side of the boat.
The engine is from a hand drill.

Part 5 - Finishing the Boat

~IMG_2275.jpg
IMG_2277.JPG
~IMG_2298.jpg
~IMG_2299.jpg
~IMG_2300.jpg
We can now finish the boat. After that, he is ready to go onto the water.

I used the Hitec Flash 5 system pack (transmitter, receiver and 4 servo's), and a speed controller of Protech of 30A max. The battery has 7 cells and provides 8.4 V. Again, most of the pictures are in the video.

Testing the Boat.

Boat test


Thank you for watching this instructable. I hope it was a good one. If there are questions, you may ask them. again, sorry if I made any language mistakes.