Lightsaber Hilt Prop
by Cyclone2019 in Craft > Costumes & Cosplay
19802 Views, 140 Favorites, 0 Comments
Lightsaber Hilt Prop
Hi, this is my first instructable!
I'm going to show you how to make a prop lightsaber hilt or handle.
Please tell me what you think in the comments.This took me about an hour and a half to make and is not that hard, you will only need basic hack sawing and riviting skills.
I'm going to show you how to make a prop lightsaber hilt or handle.
Please tell me what you think in the comments.This took me about an hour and a half to make and is not that hard, you will only need basic hack sawing and riviting skills.
Materials
For this you will need
2 chrome plated tubes (one should fit into the other)
Around 11 rivets
tap handle
Optional:paint
Tools
Hacksaw
drill-press
Pop riviter
2 chrome plated tubes (one should fit into the other)
Around 11 rivets
tap handle
Optional:paint
Tools
Hacksaw
drill-press
Pop riviter
Start by cutting the two bars to size.
Next drill 4 holes in the tap handle and larger bar then rivet them on.
then rivet the smaller bar into the larger bar ( cut the large bar 4cm away from the tap handle)
measure 6cm and then rivet a 9cm piece of the larger bar to the small bar and paint one rivet red and one gold/brass
finally cut a diagonal piece of the large bar and your done!
Next drill 4 holes in the tap handle and larger bar then rivet them on.
then rivet the smaller bar into the larger bar ( cut the large bar 4cm away from the tap handle)
measure 6cm and then rivet a 9cm piece of the larger bar to the small bar and paint one rivet red and one gold/brass
finally cut a diagonal piece of the large bar and your done!
Finished
So now you have your own lightsaber prop!
Tell me in the comments if you liked it or not and why.
Tell me in the comments if you liked it or not and why.