Pot Water Recycler

How to make a 3D printable water recycler for a small clay pot in Fusion 360.

Computer

Mouse

Autodesk Fusion360

3D printer (OPTOINAL)

Create a circle with a diameter of 177.80 mm.

Extrude your circle 12.7mm up.

Create a smaller circle and center on top of your extrusion with a diameter of 165.10mm.

Extrude the ring that the two circles create up 63.50mm.

Create four 25.40mm x 12.70mm rectangles on the corners, 90 degrees from each other.

Extrude all four rectangles up 25.40mm.

Filet edges as desired.

Create a square that is 12.70mm wide.

Extrude (with cut operation selected) until the hole is cut.

Step 8: Sketch the spigot.

Create a sketch on the bottom of the hole that you just created. Create a rectangle that is 13.208mm x 22mm.

Extrude your rectangle up 14.00mm.

Step 10: Make the channel in your spigot

Make a rectangle with the lengths of 12.00mm high x 9.028mm wide.

Extrude (with cut operation selected) your rectangle to cut the channel into your spigot block.

Extrude the channel even more (20mm) if a longer spigot is desired.

Your Pot Water Recycler is now complete!

Once printed, you can put a small clay pot inside of it as shown in the render below.

50% scale model used for testing.

Enjoy! 😉