Pocket Sized Disk Launcher

It had been a long time for me trying to make a shooter, but today I got the Idea of making this Disk Launcher.

It works really well and looks awesome, you can make this by following very easy steps. I wish that you like it.

All you gonna need is

1. A piece of cardboard
2. Syringe
3. Ruler
4. Marker
5. Popsicles
6. P.V.A Glue
7. Glue Gun
8. Coloured sheets
9. Scissors
10. Cutter

Now using the ruler and marker draw 2 pieces of 8x6cm. Now cut them using a knife or a pair of scissors.

Now using the marker mark 2 parallel lines with an eight cm gap between them.

Now using the scissors cut on the marks. Do the same with the other popsicle

Now paste the popsicles on the cardboard using the glue gun.

Do the same on the parallel side

Now using the knife cut the syringe into a tube, this will act as a storage unit for the disks

Now take the second cardboard and mark the circumference of the syringe and cut it. And using the Glue gun paste the tube over it

Take two popsicles and cut them of equal length to use it to pull. Now cover it with a sheet of paper

Now take both the cardboards and join them end - end using glue gun

Now make 2 grooves parallel the each other on any one end of the cardboard block to put the rubberbands in

Now take the piece which was made to pull and mark its length and cut the popsicles. paste them on any one end. And make a groove on the same end

Now through the grooves put two rubber bands and make them intersect on the puller groove as shown in the images above

Now using the paper decorate the it and the launcher is ready

Now put any small Disk or coin and pull the puller and shoot