Plywood Knife

DO NOT DO ANYTHING DUMB WITH THIS AND IF YOU DO, YOU CAN NOT BLAME IT ON ME.

Materials
Ply wood (scraps will work)
Old knife (or new)
3 small nails (that fit in the hole where the pin held the knife went in)
Tools
Dremel
Drill
Jig saw

Take the blade out of its holder.

Cut out a card board tamplate, then cut out two from plywood.

Cut a groove in one piece of the plywood.

Drill a hole(I used a 5/64 inch bit) in the groove to hold the knife. Then clamp both together and drill a hole through the already drilled hole into the other piece of wood. Then nail them together.

Drill to other holes in the wood.

Take out the nail and take them apart. Then sand it till it fits snuggly in your hand. After that, nail them together.

If your nails stick out, use your dremel to cut off the ends.

If yor blade wiggles, put super glue on were the blade touches the wood.