Plastic Bottle Bird

by Ruud van Koningsbrugge in Craft > Reuse

8786 Views, 26 Favorites, 0 Comments

Plastic Bottle Bird

DSCF3776.JPG
Reuse old empty plastic bottles as objects d'art. Look for plastic detergent bottles with a handle. Preferably not PET but HDPE, with a little 2 or 4 on the bottom. "the greasy kind of plastic". You will need some scissors, a knife, some tie-wraps, a small woodblock, two screws, acrylic primer ( I use acrylic modelling paste instead) and acrylic paint

DSCF3734.JPG
kolibrie.jpeg
DSCF3738.JPG
DSCF3737.JPG
DSCF3740.JPG
DSCF3742.JPG
Look for a bottle more or less similar to the one on the photo. Draw lines as shown.

DSCF3743.JPG
DSCF3744.JPG
DSCF3745.JPG
DSCF3747.JPG
It may be wise to start cutting the parts by cutting the handle with a knife or hacksaw. The rest can easily be done with a pair of scissors. Removing the bottom requires sometimes again saw or knife. You should end up with three parts. Try to cut them symmetrical.

DSCF3750.JPG
DSCF3752.JPG
Punch holes in the back of the head, body parts. I have a special set of pliers for this but any sharp bodkin will do. Attach head and body with one tie-wrap. Be sure to start from the inside for a cleaner look. Place the body part between the wings and mark the  four holes corresponding in body and wing parts.

DSCF3753.JPG
DSCF3754.JPG
DSCF3756.JPG
Connect body and wing part with two tie-wraps. Start from under the bird with the hole nearest to the beak. By doing that the tie-wrap will stick out in front and look like the legs or feet of the bird. Make the legs a little shorter with your scissors.

DSCF3761.JPG
DSCF3763.JPG
DSCF3767.JPG
Before painting a bit of sanding is recommended. Then cover the bird with primer or acrylic modelling paste. After drying paint everything black and let dry again. With almost dry brushes in burnt sienna, copper and ocher make a "mist" of color over the black paint. Deeper creases should remain black. Highlight some edges with gold paint, but don't overdo.

DSCF3781.JPG
DSCF3782.JPG
DSCF3784.JPG
Mount the bird on a little piece of wood, Make a little sloping edge with a saw and put two screws trough the hole of the feet.

DSCF3771.JPG
DSCF3774.JPG
Who would ever think your statue began life as a empty plastic bottle?
For more ideas you could look in my DIY book on my website: http://www.ruudvankoningsbrugge.nl/flessenboek.html.
Sadly (?) it is written in dutch, but many photo's and drawing will give you inspiration, as will the rest of the website.
When you are in a lazy mood discover my shop on etsy or facebook:  Packeredo ( as in Packe(t) redo)