Planter Box

by zposner in Living > Gardening

3582 Views, 31 Favorites, 0 Comments

Planter Box

5896632f22f7c74c2c001220.jpeg

Post-Election I have been constantly depressed about the state of the country. Knowing that gardening is therapeutic and relaxing, I decided to start a garden. However, the ground around my tiny house is terrible for growing things, it is super thick clay.

Tools/Materials

temp_53923591.jpg

Tools:

  • Crowbar
  • Hammer
  • Handsaw
  • Chop Saw

Materials:

  • Pallet
  • Sticks
  • Nails

Take the Pallet Apart

temp_484396480.jpg

Using the hammer and the crowbar, separate the pallet into pieces of wood, and nails. Make sure to remove all the nails.

Cut

temp_-1588823557.jpg
temp_-2010087056.jpg
temp_-681476892.jpg
  • Cut the square pieces of wood into halves, so you have four.
  • Cut some of the long boards in half to make the ends of the box. I only had a little left over after making the sides, so I used sticks to finish.

Assemble Pallet Wood

temp_-681476892.jpg
temp_271965200.jpg
  • Add the thick bars onto the ends of the long planks with the nails taken out of the pallet.
  • Nail the wood that you cut in the previous step to the bottom of the ends, as in the picture. If you have more wood, keep going, but I ran out of wood.

Sticks

temp_-921867506.jpg
temp_1736590786.jpg

Nail sticks to the ends, and then cut them so they do not extend over the edge. Do this to both sides. Make sure the sticks are as close to each other, as to retain the dirt.

Fill With Dirt

temp_-1325238815.jpg

This took WAY longer than I thought it would. It took about 3 wheelbarrow loads to fill it up. I was getting dirt from the back of my house, which is a 3 minute walk. It was after a rain so the path was all muddy and the wheelbarrow kept getting stuck. In the end, I got it to work.