Plant Coasters


Plant Coasters are 3 round cactus coasters placed in a decorative pot. Coasters are frequently arranged in unappealing ways in homes, making them appear ugly and out of place. Plant coasters are made to be both a decorative and practical addition to a comfortable eating or living area. They are designed to fit the environment of a cozy dining room/living room as a decor piece as well as a functional piece.
Supplies
Fusion
Prusa/Bambu Lab (PLA)
Pot (Body)


Set Units to INCHES
Create a pot body where you will put the coasters in.
- Create a sketch on the right plane and sketch the side view of a half of a pot
- symmetrically mirror the sketch, then revolve around the axis
- Create a sketch on top plane
- Draw a circle for the stick in the middle
- Extrude the circle upwards for the coasters, fillet to make a round edge
Coasters


Create 3 coasters
- On the top plane, create a sketch and draw one circle
- ^^ this circle can be any size, as long as it's smaller than the pot
- Draw a smaller circle inside (the same size as the stick)
- Extrude these circles upwards, leaving the inside circle empty like a hole
- Duplicate this coaster 2 times in order to make 3 coasters
Cactus Topper



To create a cactus topper:
- Create a circle on the top plane and finish sketch
- ^^ this circle should be the same size as the other coasters
- On the right plane, create a fit point spline arch on one side that is tangent to the sides of a rectangle, then mirror
- Do the same thing with with the left plane
- Create a loft, and use the fit point splines as rails to create a round cactus tip shape
- Create a small hole which is the same size as the stick (extrude half way through)
Assemble

Assemble the piece
You're done now!