Phone/iPad Holder
A holder that has two different angled platforms to hold a phone or tablet. (Orange pieces will be broken off after printed)
Supplies
3D printer and fillament. A computer to design print is also needed.
Make a flat platform laying on the XY axis. Add an angled platform protruding up at a preferred angle, on the z-axis.
Add a small platform coming off of the angled one, this is to hold the phone. Then scale down step one and repeat coming off the side of the larger platform. Make the angle of this raised piece more or less steep depending on preference.
Add thin long rods connecting overhangs to the ground piece, these are called supports and will be broken of after printed.
Import into a slicer such as Cura and slice the print. After slicing the design should be ready to print.