Phone Holder Charging Stand Dock

This 3D Print figure is a phone holding charging station. The main goal is to hold the phone and charge it underneath, so that it can charge peacefully and you cant watch, play, or have a meeting at the same time.

Phone

Charging wire (Lightning or USB-C)

Fusion 360

PLA Filament

1. Start a New Sketch:
2. Open Fusion 360 and create a new sketch on the Front Plane.
3. Create the Phone Holder Rectangle:
4. Draw a rectangle representing the phone's resting surface.
5. Use dimensions close to 4.3 in. x 2.5 in. (adjust for your phone's size).
6. Extrude the rectangle 0.24 in. thick.
7. Create the Bottom Lip:
8. Draw a small extruded lip (0.4 in. high, 0.2 in. thick) at the bottom to hold the phone in place.
9. Fillet the Corners (Optional):
10. Apply a fillet (0.12-0.20 in.) to smooth out edges for a more polished look.
11. Add an Overall Slot on the bottom lip (Symmetric extrude cut)
12. 0.747 in. width x 0.297 in. height; 1.044 in. wide (Charging output hole)

1. Select the Profile: Choose the entire phone holder sketch.
2. Extrude the Frame: Use the Extrude tool to add depth (~0.4 in.) to the frame.

1. Create New Sketch on the Bottom Surface: Start a new sketch on the back bottom center of the holder.
2. Draw a Circle: Draw a small circle (0.25-0.5 in. diameter) at the center to act as a support rod.
3. Extrude the Rod: Use the Extrude tool to pull the rod downward to the base (3-4 in. length).

1. Create New Sketch on the Bottom of the Rod:
2. Start a sketch on the bottom plane of the rod.
3. Draw the Circular Base:
4. Draw a large circle (3-5 in. diameter) for stability.
5. Extrude the Base:
6. Use the Extrude tool to pull the base up (0.2-0.4 in. thick).

1. Modify the Rod Angle:
2. Select the Move/Rotate tool and adjust the phone holder's tilt (20-30° backward) for a comfortable viewing angle.
3. Join Components:
4. Ensure the frame, rod, and base are joined as one solid body.

1. Add Fillets to smooth sharp edges.
2. Use Chamfers to refine transitions.
3. Apply Materials & Colors for a more realistic look.

Now you have a tilted Phone Charging Dock designed in Fusion 360!