Personal Computer Build Project

I have made a PC, this is how I did it!!!!

CPU, Motherboard, thermal paste, Ram, PC case with fans, Heatsink.

Use the triangle to see the correct orientation. Gently place on the array. make sure it can not move off of it.

Pull the lever back so the metal notch can slide under the pin, pull the lever down and under the hook, don't be afraid to apply some amount of force.

Put a small pea size amount of thermal paste on the center of the CPU. If you add too much (overflowing on the side), wipe the CPU clean and try again.

screw down the heatsink and be careful it is fragile.

Apply even pressure and make sure its facing the right way. You should hear a click.

screw in the screws to the standoff holes (very important).

screw in the power supply of the back and feed the cables into the main part of the case. Put the CPU 4/8 cable through the hole closest to the IO shield.

The power cables from the power supply should now go to the motherboard. 20/24 pin goes to the motherboard, 4/8 pin goes to the CPU.

connect the front panel audio connections to the output.

attach the power switch wires to there labeled spots and make sure the text is facing away from the motherboard.

connect the USB connections to the pins on the motherboard.

connect the three fans to the fan outputs.

Screw the front and back panels on.

Connect the computer to a monitor and see if there is a bios beep and display.