Pen Launcher

A Pen Launcher

1 Sheet of Sandpaper, 1 Pair of Scissors, 2 Pilot G2 Pens, 3 Zipties

Dissasemble your first G2, Screw of the top and take out the ink shell, use the ink shell to poke out the thumb cap, and gear, then bang the top part on a hard surface sharp side up, the spring should come out.

Put in the back part, in order, these parts: Thumb cap, Spring, Gear. Then get your ink shell and press down inside of the back part (Clear Side!!!) until you hear a click. Then you can press the thumbcap for a test fire.

First take your other G2 and get out the spring, then take the ink chamber and get the nub-like part at the end, and force it into the spring, put that into the back part. Then screw the front part on. Then grab your scissors and bore out the top part so a bamboo skewer fits in easily. Cut the skewer so it is about 3 1/2 inches. Push the skewer in till you hear a click, and shoot!

Get the topp part of your SECOND G2 and put it on your pen launcher, then get the zip ties, and zip it on there tightliy, finally cut the ties. You now have a scope.

Get your sandpaper and polish any rough areas. It should now look like the one on the top.

PS's:

It is very hard to get the butt cap of the ink shell into the spring, if you are here congrats.

When you wish to fire, push it forward and stop abruptly when you push the butt cap.

Thanks for looking at this.