Paracord Wrist Support Band for Slingshot

by Noble_Knight in Outside > Paracord

7993 Views, 92 Favorites, 0 Comments

Paracord Wrist Support Band for Slingshot

temp_813148996.jpg
temp_1441047232.jpg

My wrist support strap on my Daisy p51 started to rip. I decided it was time for an upgrade, instead of leaving it to have my hand hit my face from pulling back on the rubber. I had some paracord so "why not?" I asked myself...

Materials

temp_700674856.jpg

18 feet of paracord
Scissors
Fids
Lighter
Somthing metallic with a flat side

Lark's Head

temp_69940069.jpg
temp_-1446494908.jpg
temp_1644284951.jpg
temp_-447240718.jpg

First off I had to modify my slingshot to fit and hold 8 bights of cord and I did that with a bit of duct tape. Make a Lark's Head knot and put it around one of the metal wrist supports. You could potentially put it straight on the metal but I decided I didn't want any chance of the band slipping off.

Inner Cordage

temp_1883617380.jpg
temp_-1682655233.jpg
temp_45975603.jpg
temp_1492786353.jpg

Wrap the cord like so. When turning it to the side it should look like a figure 8. There should be 8 strands going along the middle. The more strands in the middle the more soft the wrist support will be as it will be wider and thicker.

Fishtail Wrap

temp_-414303910.jpg
temp_576006345.jpg
temp_17689719.jpg
temp_-1704046809.jpg
temp_-2094919398.jpg
temp_-1104204660.jpg
temp_-2112062888.jpg
temp_949847124.jpg
temp_1097611483.jpg

Fishtail weave. I had to stop close to the end and put some fids on to finish up. You could stop right here, I continued to do another wrap over that because I didn't want the ends sticking out the bottom on my wrist. Keep pushing the weave to the top try to get as much cord as possible but try not to make the weave too tight. The looser -> the softer, the tighter-> the harder.

Half Hitch Wrap

temp_172767072.jpg
temp_-1495791505.jpg
temp_1514619639.jpg
temp_-1964583111.jpg
temp_1745331585.jpg

When doing this try to keep the wrap as loose as possible, but try to fill up the space evenly. Pay attention to finishing up the end-> Make sure it's very secure

Finishing

temp_60197632.jpg
temp_-1460898660.jpg
temp_-1421771932.jpg

Snip, melt, and flatten/smooth

Finished

temp_2125437259.jpg

Ta-Da! My wrist strap turned out a little stiff (it's not going anywhere) so it digs into my forearm a little. For that reason I insisted upon making it a little looser.

Thank you for reading! If you have any questions please leave them in the comments. I'm open for any advice