Paper Tyhpoon
![IMG_2639.JPG](/proxy/?url=https://content.instructables.com/FND/OCWA/IW5JBU3H/FNDOCWAIW5JBU3H.jpg&filename=IMG_2639.JPG)
![IMG_1795.jpg](/proxy/?url=https://content.instructables.com/FW4/OFMI/IW5JBU3T/FW4OFMIIW5JBU3T.jpg&filename=IMG_1795.jpg)
This Instructable documents reproducing a black and white image using laser cut strips of paper. Each paper strip is printed with a gradient, then laser cut to a depth matching a specific column of pixels from the source image. The strips can be thought of as a cross section of the height map of the image.
The Strip
![testStrip.jpg](/proxy/?url=https://content.instructables.com/FQR/0FYX/IW5JBU4F/FQR0FYXIW5JBU4F.jpg&filename=testStrip.jpg)
I wrote Octave code that would sample columns of pixels at a fixed interval and convert this column of intensities into a vector drawing. Black pixels would be set to a minimum distance and white pixels were set to the maximum strip width. This vector drawing was saved as an SVG. In a separate jpg file, a gradient spanning the strips width was created.
The Support
![panel1.jpg](/proxy/?url=https://content.instructables.com/F3R/HFNA/IW5JBU3J/F3RHFNAIW5JBU3J.jpg&filename=panel1.jpg)
To guide the gluing of the strips, I laser cut a pattern into several 1/4” thick wood panels. Each guide line is 1/16” apart. I varied their appearance to avoid confusion. I backed the panels with a frame for support.
3. Printing, Cutting, Folding and Gluing, 2880 Times
![IMG_2652.JPG](/proxy/?url=https://content.instructables.com/FYJ/RNA5/IW5JBULM/FYJRNA5IW5JBULM.jpg&filename=IMG_2652.JPG)
![IMG_2544.JPG](/proxy/?url=https://content.instructables.com/FKY/ENRX/IW5JBULS/FKYENRXIW5JBULS.jpg&filename=IMG_2544.JPG)
![IMG_2558.JPG](/proxy/?url=https://content.instructables.com/FFL/3QYH/IW5JBUNW/FFL3QYHIW5JBUNW.jpg&filename=IMG_2558.JPG)
![IMG_2639.JPG](/proxy/?url=https://content.instructables.com/F6O/1R3E/IW5JBULE/F6O1R3EIW5JBULE.jpg&filename=IMG_2639.JPG)
Each piece of paper was first printed with several gradients, and then laser cut. I folded each strip at its base at about a 30 degree angle, using the guide shown, to give the piece some volume. Then I glued each strip in place following the guide lines, using a pH neutral glue. It took 3 strips to span the vertical distance. The total number of strips for the 60” wide piece was 2880.