Padlock
![Working padlock (1).png](/proxy/?url=https://content.instructables.com/FCW/JLLR/LOWX1JRK/FCWJLLRLOWX1JRK.png&filename=Working padlock (1).png)
This Is a padlock the code is 000. This should be working.
Supplies
380g of any color filament
3D printer
My project which is below
Downloads
Print the Padlock Pieces
![Working padlock.png](/proxy/?url=https://content.instructables.com/FNG/KV3S/LOWX1LS0/FNGKV3SLOWX1LS0.png&filename=Working padlock.png)
Print the padlock pieces
Assemble
![Working padlock (4).png](/proxy/?url=https://content.instructables.com/FJ6/KFKD/LOWX1V0J/FJ6KFKDLOWX1V0J.png&filename=Working padlock (4).png)
After printed, line up the 3 disks in the padlock body and put the flat stopper at the bottom of the line
Finish
![Working padlock (3).png](/proxy/?url=https://content.instructables.com/FVR/53PP/LOWX1VFK/FVR53PPLOWX1VFK.png&filename=Working padlock (3).png)
Put the padlock stick through all the aligned holes and then your done