PVC Toothbrush Holder - Inside Cabinet Door

Simple project. Minimal tools, no gluing. Get your toothbrushes off the vanity and away from germs.

I did see this project done on the Internet.

I cut 1" PVC into 4.5" lengths. Bought caps for the bottom. Drilled a hole in each 1" from top to hold hook.

Don't glue them.

Makes less noise when you open and close cabinet.

Measure and mark a good spot on your cabinet. Make sure your toothbrush and PVC clear anything in the cabinet. Center and attach a 3M hook on the cabinet. I used the ones that you can pull off later.

Use the other tubes as a guide on where to line up the others.

Enjoy