PVC Snowboard Rail

The materials I used were five 2¨ by 4¨s and a PVC pipe that was almost 10 feet long. I also had to use a lot of screws as well as a screw gun.

We first had to measure exactly how long our PVC pipe was and then cut three of the 2¨ by 4¨s to that length.

Once I had them cut, I lined up two of the pieces and drilled them together.

Then I did the same on the other side with the leftover 2¨ by 4¨ causing it to look like this.

Then I cut out the legs for my rail which were only a couple of feet long but you can change the length of them depending on how tall you want the rail to be.

Then I drilled in the first leg which looked like this.

Once I had all of the legs in it looked like this.

Then all I had left was to put the PVC on top and drill in screws into it from the bottom and it was done.

This is what the rail looks like when it's all done and set up.