PIR SENSOR, NEOPIXEL STRIP AND LIGHT BULB (GROUP 3)

Important components are prepared and used for the construction of this circuit.

Components used are PIR sensor, Neopixel(strip 4), LED, Breadboard, Arduino Uno board and Resistor.

Connect the Signal terminal to pin 2. Connect Power terminal to 5V. Connect Ground terminal to GND.

An LED is connected with a resistor of 1kilo ohm to pin 13.

The Terminal IN of the Neopixel is connected to pin 6 with a resistor of 1kilo ohm. Connect Power Terminal to 5V. Connect Ground terminal to GND.

The circuit is completed and sensor is working as our expected result.