Outdoor Chair

by Papernot in Workshop > Furniture

148 Views, 1 Favorites, 0 Comments

Outdoor Chair

20 copy.jpg
intro.jpg

I made an outdoor chair, the first of 4 planned to match a wooden outdoor table from IKEA. I like modern furniture forms, so I patterned it after DWR’s Block Island Dining Chair, which is now out of production, but used to cost around $700 each. Ours was put together for much less than that. Overall, a productive exercise for my son, shown in the photos, to introduce him to woodworking.

Supplies

02.jpg

I used all cedar wood, wooden dowels, wood glue and screws. I thought I needed a metal plate to reinforce the seat, but the dowels and screws turned out fine. Tools used were a miter saw, a pull saw and chisel for the dovetail cuts, an ice pick and mounted Dremel to make pilot holes, a bench vise to hold the lumber for drilling the dowel holes, wooden dowels, a drill driver and a countersink bit.

I used 2 sizes of cedar wood: 28 pieces of 3x1x8 ft lumber, and 1 piece of 4x1x8ft for the back & bottom supports.

Cutting the Lumber

01.jpg
02.jpg
03.jpg
04.jpg
04b.jpg
05.jpg
06.jpg
07.jpg
08.jpg

A rough sketch was made, then lumber was cut to size. Then it's making the cuts for the dovetail joints using a pull saw. After that, cutting the 4x1 lumber for the reclining back & bottom supports, then sanding everything.

Assembling the Pieces

09.jpg
10.jpg
11a .jpg
11b.jpg
12.jpg
13.jpg
14.jpg
15.jpg
16.jpg
17.jpg
18.jpg
19.jpg
20.jpg
21.jpg
22.jpg
23.jpg

Pilot holes were punched in with an ice pick as guide. Then using a mounted Dremel, we drilled through the wood using a smaller bit than the screws to be used. These were done to avoid cracking the wood. Then we follow those with a countersink bit, so the screw heads would be flushed below the surface. Next, it's making holes for the dowels by mounting the wood into a bench vise. The dowels were then attached using wood glue. After that, it's attaching the slats to the back and bottom supports using screws and a drill driver. We don't drive the screws all the way in. After making sure, everything is square & level, we finish driving them in with a screwdriver. Then the main parts are assembled. To hide the screws, we used dowels again. We drive them about a quarter inch deeper, used a dowel that's the same size as the screw head, glued it in, then cut flush to the surface with a pull saw.

Finishing

24.jpg
25 copy.jpg

Finally, we sand everything down, dusted off and cleaned everything, before painting over with 3 coats of exterior paint.