Omniwing Sparrow

The omniwing sparrow is a very simple but fancy plane designed for tricks. If it is distance you want, go to my omniwing godspeed.
It is also loosely derived from the omniwing godspeed.

2 sheets of paper, scissors, tape, pencil, and some sort of measurement.

Pic 1. Take a paper, and fold it in half.
Pic 2. Take the top corners and fold them in.
Pic 3. Take the tip and fold it in.
Pic 4. Take the New top corners and fold them in. (Be sure to not fold beyond the second fold and middle.)
Pic 5. Fold in half, again.
Pic 6. Dot right here.
Pic 7. Dot one inch in.
Pic 8. Draw between the dots.
Pic 9. Cut on the line.
Pic 10. Open the wings.
Pic 11. Erase the dots and the line.

Pic 1. Take your wings and fold the paper at this point.
Pic 2. Flip the wings.
Pic 3. Fold down the new Top corners.
Pic 4. Flip the wings, again.
Pic 5. Fold up the new bottom corners.
Pic 6. Flip the wings, also again.
Pic 7. Fold down the new top corners, and tape them.
Pic 8. Dot one inch in.
Pic 9. Dot again on the other side.
Pic 10-12. Fold the corners over so that the dots are at the corners.

Pic 1. Take the other paper and hotdog fold it.
Pic 2. Unfold it.
Pic 3. Cut along the crease, and discard the remnant.
Pic 4. Hotdog fold it.
Pic 5. Unfold last fold.
Pic 6. Fold into crease.
Pic 7. Fold in half.
Pic 8. Dot two inches in.
Pic 9. Cut to dots.
Pic 10. Fold in corners.
Pic 11. Tape.
Pic 12. Dot half an inch in.
Pic 13. Cut to dots.

Pic 1-3. Fold the flaps In at a 75 degree angle.
Pic 4-5. Insert tail.(you may want/need to widen the slot)
Pic 6. Tape the tail in.

Have fun with your new sparrow!! It may be a bit tricky to throw it, all you need to do is put your middle and index finger beside the tail, and thumb on the nose. Then throw!!!