Of Ordinary Bolts, Homemade for Sharpening Blades and Knives
2811 Views, 41 Favorites, 0 Comments
Of Ordinary Bolts, Homemade for Sharpening Blades and Knives
In this material, we will make a very simple homemade product from an ordinary bolt and bearing. I am sure that many will like this device.
We Will Need a 14 Mm Bolt, Because I Did Not Have a Suitable Bolt, I Will Use a Hairpin. We Measure 12 Cm. and Cut It Off Using Angle Grinders.
Clamp the Workpiece in a Vice and Draw a Line in the Center of the Hairpin.
We Need to Make a Through Cut With a Grinder, First, I Used a 1 Mm Disc.
Then He Put the Disc a Little More and Increased the Thickness of the Cut.
Now We Need Two Bearings.
And a Few Washers With Nuts.
We Begin to Assemble Our Simple Design.
We Also Do It on the Other Hand.
Place Sandpaper on a Flat Surface.
We Remove the Knife From the Planer and Install It in Our Homemade Product.
As You Already Understood, the Sharpening Angle Is Easily Adjustable, the Further the Blade, the Smaller the Angle.
In the Same Way, the Chisel Blade Can Be Sharpened.
Video Version
If you liked this project, then be sure to subscribe to my YouTube channel and check out some of my other Instructables.