No Sew Fleece Tie Blanket JIG

So i watched my sister and mom make a no sew tie blanket. what a pain in the @ss! you have to keep measuring and pinning needles and it took them hours to make blankets. so i came up with this jig, that is cheap and folds for storage.

STUFF YOU WILL NEED-

• 2 sheets of 1/4" masonite
• a piece of sheet rubber
• contact cement
• aluminum tape or duct tape

TOOLS YOU NEED-

• drill
• speed square
• 1/2" drill bit - i used a mortise bit
• tape measure
• colored pencil with bright lead
• scrap 1x wood to make a saw jig
• chalk line or long straight edge

• cut the masonite in to 2 pieces 30x50 and 1 piece 12x60
• when you put them together it will be 60x50
• use the tape measure and mark 4" on each corner and snap a line to connect them.
• then after that mark 1" then 1/2" then 1" then 1/2" untill you reach the other end. do all 4 sides.
• take the speed square and mark lines.
• take the 1/2" bit and drill a hole at the end of every 1/2" mark like in the photos.

• take the scrape 1x and make a jig that slides down the masonite but extends out to keep the back of the saw straight.
• go around the masonite and cut all the lines to connect to the holes that were drilled.
• take the 12" piece and mark, drill, and cut the same way.
• find center of the 12" piece and make a handle.
• cut the rubber to go about 12' on each side.
• glue the masonite and the rubber wait till all most dry then stick together and tape the edges.

• unfold on kitchen table
• spreed both layers of fleece out on top of it
• set the 12" jig on top and cut the fleece between each wood groove
• do all for sides and remove top jig
• all you need to do is tie all the pieces and DONE!
• you can do a blanket in 15 to 20 minuets.