New Casing From Lego Brick
![broken-usb-5.jpg](/proxy/?url=https://content.instructables.com/F7S/QUTC/K3RPWRST/F7SQUTCK3RPWRST.jpg&filename=broken-usb-5.jpg)
My old tiny pendrive stopped opening. It's time to give it second life.
This time I decided to use glue gun. There is no blinking led and the Lego Brick is very tiny. I decided to use red 2x1 red brick which is easy available. You will also need small flat screwdriver and sharp knife.
ABC... Done
![broken-usb-2.jpg](/proxy/?url=https://content.instructables.com/FU1/BA25/K3RPWRSO/FU1BA25K3RPWRSO.jpg&filename=broken-usb-2.jpg)
![broken-usb-3.jpg](/proxy/?url=https://content.instructables.com/F0U/EALN/K3RPWRSR/F0UEALNK3RPWRSR.jpg&filename=broken-usb-3.jpg)
![broken-usb-4.jpg](/proxy/?url=https://content.instructables.com/FDA/6KDO/K3RPWRSS/FDA6KDOK3RPWRSS.jpg&filename=broken-usb-4.jpg)
![broken-usb-5.jpg](/proxy/?url=https://content.instructables.com/F7S/QUTC/K3RPWRST/F7SQUTCK3RPWRST.jpg&filename=broken-usb-5.jpg)
![broken-usb-6.jpg](/proxy/?url=https://content.instructables.com/FT4/EL6P/K3RPWRSU/FT4EL6PK3RPWRSU.jpg&filename=broken-usb-6.jpg)
A. I removed pendrive from old case. It was easy because there where no screw, glue or something like that. I was enough to press a screwdriver into the slot and eject the disk.
B. Most scary part ;) I need to cut plastic back to fit the case. Watch your fingers!
C. I used glue gun with transparent glue. It is enough to wipe off glue residue while it is hot.
Done :)