Nerf Strikefire Power Mod

Ahh the classic Nerf blaster, the 2006 Nerf strikefire. Today i will show you how to remove the strikefire's air restrictor and show you how to get a better seal between your piston and cylinder. 

First you want to remove the slide screws and remove the slide.

Now you want to remove all the other frame screws after you have removed the slide, Now you just take one side off the blaster.

Now you want to remove the piston from the plunger and remove the o-ring.

Now you want to take a pipe cutter and cut on the line by the end of the plunger. In here you will find the AR.

Now, you want to remove the air restrictor, you pull out the small spring and the loose plastic bit.

Now at this step you need to drill out the center to allow higher air flow.

Now you can  take a file and file down the sharp edges where the cut was made.

Now you want to take super glue and seal the two pieces back together and let it dry.

Now at this step you want to seal up the hole on the side of the barrel with super glue.

Now you want to Take thread Seal Tape and wrap it around the plunger where the o-ring goes. After this, you put to o-ring back on. The tape pushes out the o-ring for a better seal.

Now you want to take Silicone grease or vasoline and rub it in the plunger and on the Piston.

Now you just put all the pieces back in place and screw it all back together. you can also make a distinct marking to remember its the Modded blaster.

You Can also increase power by using 2 o-rings,A stonger spring or one bigger o ring.
 * You can also use a tight brass barrel.