Nerf Jolt

This Instructable will show you how to make a Nerf Jolt out of K'NEX.

You will need 8 white connectors, 2 red rods, 2 yellow rods, 4 blue rods, 4 green rods, 1 orange connector, 1 white rod, 5 orange bendy rods, 3 rubber bands, 2 green connectors, 2 yellow , 2 small blue caps, 8 small blue separators, 5 grey separators, 2 black caps, 10 large purple caps, and 2 blue connectors. You also need purple bendy rods (not shown yet) for ammo.

Build this piece, then add yellow rods.

Stack the two blue pieces facing different directions.

Add the orange rods, then add two blue rods between them.

Add the separators and caps to the blue rods as shown. Next, slide down the orange rods.

Add the yellow connectors as shown. Make sure that the direction they are going up has the center connection on the top.

Add a blue rod to the lower end of the yellows.

Add the orange rod to the top connection. Next, attach the yellows to the yellow rods on the barrel. Next, connect the orange rod to the barrel as shown.

At this point, your gun should look like this.

Make two of these pieces and stack them.

Insert the trigger, and add a blue rod through it. Add caps and separators to both sides.

Make this piece.

Attach rubber bands to the trigger as shown.

Insert the plunger through the hole in the back. Next, add a rubber band.

To prime, pull back the plunger AMD press up the trigger. Then load the ammo, and pull the trigger.

You now have a Nerf Jolt! Enjoy!!!