Mjolnir Foam Hammer

Materials:

Faux Leather

Gorilla tape

Elmers multi-purpose spray adhesive

Spray insulating foam

Foam primer

Rustoleum hammered paint

8-inch serrated knife

Sandpaper 60 grit and 120 grit

Broomstick

Fast drying drywall mud

Respirator

Safety goggles

Measuring tape

Ruler

Marker

Cardboard box

Wax paper

Pam

Hand saw

Shoebox

Measure the broom handle to 16.6535 inches and draw a marker line at that point then Using the handsaw, cut along the marker line

Line the walls of the shoebox with wax paper and spray them with pam

Cut a hole in the center of your shoe box lid and place the handle inside

Cut a few entry points to spray foam into the box and then spray it until the box is full

Wait 24 hours

Remove the foam from the box and peel away all wax paper and cut foam to size

Cover hammer in drywall mud

Sandpaper the drywall mud to size

Spray Foam Primer onto the Hammer

Spraypaint the hammer to look metallic

Cut faux leather into strips twice the length of the handle

Use Elmer's spray adhesive to coat the back of the leather and wrap around the handle

Roll the remaining Faux Leather at the end of the handle tightly into a coil for loop then cut Gorilla tape into very thin strips and loop around the coil and attach back to handle

You have your own Mjolnir to Wield Thor's Power