Mini Skateboard

Lay down 5 pieces of veneer wood. Have 3 pieces with the grain facing vertical and 2 pieces with the grain facing horizontal.

Put the wood glue on the pieces of wood. (Don't be afraid to overdo it on glue)

Lay the pieces of wood together in the mold. Wait 24 hours for it to fully dry.

Drill the wholes of the board.

Sketch out the desired shape of the board and saw near the lines.

Sand all the way to the lines now and make sure to round the edges of the board.

Print out the graphic wanted and cut to a reasonable size.

Put glue on the board and apply the graphic. DO NOT put press on the graphic with your fingers.

Press the board into the towel to even the pressure on the paper. Wait about a hour.

Sand around the edges of the paper with a fine grit sandpaper to get rid of the access.

Finally apply a protective coat (glossy looks better) and wait for it to dry.