Mini K'nex Super Bow

by hi_im_E in Craft > Costumes & Cosplay

26 Views, 1 Favorites, 0 Comments

Mini K'nex Super Bow

IMG_2913.jpeg

Hi my name is E! Today I will show you how to make a mini bow and arrow just out of K'nex. It is super simple and takes 5-10 minutes, based on how fast you can be. In the end, it shoots pretty far so stick around to make one!

Supplies

17 Blue Pieces

12 Yellow Pieces

20 Yellow Connectors

4 Grey Connectors

1 Rubber Band

Scotch Tape or Painter's Tape

The Front of the Bow

image (1).jpg

Let's start by making the front of the bow. This is where the arrow will go when it is loaded. This step is quite simple. Use 2 Yellow Connectors and 4 Blue Pieces to make the parts on the top of the picture. Use 2 Yellow Connectors and 2 Yellow Pieces to make the parts on the bottom.

Reinforcing

IMG_2915.jpeg
IMG_2916.jpeg

Next take 4 Blue Pieces and attach them to the sides of the Yellow Connectors. This can be very frustrating, but make sure to keep trying!

The Supporting Parts

IMG_2918 (1).jpeg

Our next step is to make the securing parts of the bow. This keeps everything together. This step can be a little tricky, so be patient. Take 4 Yellow Connectors and 1 Blue Piece to make this part. If you want to be working ahead, make 4 of these!

Connecting

IMG_2921.jpeg

Now, connect everything together. If you did it right, it should look like this picture.

The Yellow Pieces

IMG_2923.jpeg
IMG_2924.jpeg

Now take 4 Yellow Pieces and snap them into the 2 Yellow Connectors at the top. It will look like the picture above. Do this on both sides.

More Supporting Parts

IMG_2918 (1).jpeg

If you didn't read Step 3, then here you go: We are making some more supporting parts. If you need a refresher on how to make them, scroll back up to Step 3.

Almost Done

IMG_2926.jpeg

Connect the supporting pieces to the big chunk of the bow. We are almost done!

Finishing the Bow

IMG_2912.jpeg

Sorry in advance for the bad picture! In the middle of the Yellow Connectors, there is a hole. You want to take 2 Blue Pieces and put them through the hole until they poke through the other side. Next pull out a little on the Blue Pieces and slide the Rubber on. Slide the Blue Pieces back through the hole and put on the Grey Connectors on the end of each Blue Piece. Finally, in the middle of the rubber band, use your tape and tightly roll a little piece around the rubber band. This will help you pull back farther to get more power.

Safety

Make sure not to shoot anyone in the eye with the bow because it hurts!