MinPen Mod!
Well, this kid named Danny that is in one of my honors classes has like thousands of these generic transparent pens that he transforms into blow dart guns. I came up with this while sitting in Honors Physical Science. Not really amazing, kind of silly, (really silly), but i guess if your this crunched for space it will help :)
Materials
Okay first off, you will need a nice sharp knife, or a hacksaw, or some pliers ( Whatever you prefer!) And a regular generic pen.
Step 1-Remove Writing End of Pen
Okay first, remove the "writing" end of the pen. Once that is complete we can move on to step 2!
Cut the Ink Holder/pen Tubing.
Okay, grab your knife/sharp object, what I did was start sawing, and once I got further into the pen tubing I pushed down and it went right through it. I came out with what you can see in picture 2, (Cut Tubing..)
Cut Ink
In some cases this could get messy, so proceed to finish over a paper towel or rag. First, measure the tubing to the ink so you know where exactly to cut (First Picture). And the of course cut the ink. I left my fingers where I measured so I could cut it right outside of them and make the best fit.
Put Ink in Tube and Finish the Project!
Now all you have to do is slide the ink back in snugly as a bugly and your finished. Here is some pictures of me doing so, and what I came out with.