Microfreak Stand / Small Synth Stand / Laptop Stand

Desktop stand for a small synthesizer or laptop. The plans are sized for an Arturia Microfreak. Plans can be adjusted as required.

Scrap 1/2" plywood

3/8" dowel rod

Wood glue

Wood finishing oil

Tools:

Jig saw

Hand saw

Drill with 3/8" bit

Sandpaper

Print out PDF of plans. Trace onto 1/2" plywood and cut out with a jig saw. Drill 3/8" holes as indicated on plans. Sand cut edges smooth.

For a lower stand, remove an inch or so from the vertical rise of the plans.

Cut dowel to desired length. For a Microfreak 11 3/4"" works well to not interfere with the rubber pads on the bottom of the Microfreak. Glue dowel into plywood.

Apply wood oil or urethane are desired. I like walnut oil.