Mans Pocket Credit Card Holder With Chain

Time to start!

1.) You will need tinkercad.

2.) You'll need either a chain necklace or a small chain-link chain

On tinkercad you'll need to get 5 boxes out.

Of those boxes make three boxes the dimensions below.

85.73mm in length

and

60mm in width

and

2.25mm in highth

now you'll need to make the radius of the boxes that are scaled 1.95, then you'll need to make it a hole(I couldn't show how to make a hole from a solid through the screenshot so you'll have to do that on your own!).

Now you'll need to make one of the other boxes the dimensions below.

91mm in length

67mm in width

and

20 high

Now you'll need to make the last box the dimensions below.

24mm in length

73mm in width

and

22 high

Now you'll need to take the big box and align the boxes shaped like credit cards onto it.

Now you'll need to make a copy of the credit card holder (not the lid). Then you'll need to take that copy and make the copy a hole. After that, you'll need to take the block-shaped lid and the credit card holder hole and align the lid at the top. Finally, you'll need to group them, and now you have a lid!)

Now add a loop using 2 cylinders, make one a hole and make the other one a solid. Next, 3d print your piece.