Making a M.C.Escher's "Winged Lion" End Grain Cutting Board

I like M.C.Escher's creativity. Sometimes I make boards based on his paintings. A month ago I made a new board.

You can watch this video

FREE tutorial "THE BASICS OF MAKING END GRAIN CUTTING BOARDS" - http://eepurl.com/brMc_5

Thanks,

Andrei Muntian

http://mtmwood.com/en/

Escher painted the "Winged lion" (#66) in 1945.

This is a tessellated image. All lions are absolutely identical, the light lion is a mirror copy of dark lion.

I made drawing. It consists of four curved lines. Two bottom lines are the reversed copies of two upper lines.

I used black walnut and movingui to fit the colors of the Escher's painting.

I use 2 mm end mill bit and 30-degree V-bit.

I made pockets in the walnut board.

Then I mirror the drawing and made the movingui inlay.

Pocket:

Start depth - 0 mm

Flat depth - 7 mm

Inlay:

Start depth - 5 mm
Flat depth - 3 mm

So I got 2 mm gap between the pocket and the inlay and 3 mm gap between the top of the pocket and the bottom of the inlay.

The feed rate for clearance tool (end mill bit) - 15 mm/sec, for V-bit - 12 mm/sec.

I saw off the edges of the inlay at the band saw.

Then I glued the pocket and the mirror inlay.

This sandwich must be clamped very well for the best fit.

Next day I sand the board at the drum sander in several passes (maybe 20-30).

I sawed the edges off to make a "copy" of the whole painting.

I used Far-East walnut for the border. It is lighter than American black walnut.

Next day I sanded the board with the border at the drum sander. I sanded until the chin of the dark lion not joined with the tail of the next dark lion.

Then I sand the board with the rotary sander.

I treated the board with the mineral oil in the oil bath.

Here is the result.

Thanks for watching!