Make a PVC Microphone Shockmount for $1.20

by retrofilms in Craft > Photography

42501 Views, 106 Favorites, 0 Comments

Make a PVC Microphone Shockmount for $1.20

me with shockmount.jpg
What is a shockmount?  If want to record dialogue for your movie, using a shotgun mic on the end of a boom pole is a good way to capture it.  The problem is that if your mic is connected directly to the pole, it will pick up noise from the operator's hands.  A shockmount suspends the mic up and away from this potential noise.

A few years ago, I published an Instructable for a rubber band mic shockmount that was became featured on the home page.  I received positive feedback, but after finally using it in the field, I didn't like it.  The rubber bands tended to move too much and the whole thing looked cheap.  I think I've come up with a better build that is tougher, easier to make, and less expensive.

Parts List

parts.jpg
1/2" PVC pipe scrap (2.5" long) - FREE (or just over a buck for a 10' length)
4 rubber bands - FREE (rubber bands are everywhere)
1  1/4" x 1/2" Tee fitting - $1.20 at Lowe's

Tools

tools.jpg
Pencil
Dremel
PVC ratcheting cutters

Place Bands Around Large End of Tee Fitting

placing bands 1.jpg
placing bands 2.jpg
The idea here is to create a narrow hole for the microphone to rest in.

Mark Where Bands Lie With Pencil

mark with pencil.jpg
Leave a mark on both sides of each rubber band.  Pencil is better than ink as you can easily rub off leftover marks when done.

Remove Bands, Dremel, Replace

dremel notches.jpg
replace bands.jpg
Time to create the notches which will give the bands a firm grip on the tube.

Insert PVC Pipe and You Are Done!

insert pvc.jpg
finished product.jpg
If you like this kind of thing, come check out The Frugal Filmmaker!

Here's the Video Version...