Make a Mini Bic Pen

This is my fourth instructable, and I hope you all like it.
I have been making these pens for about three years for my friends at school, and they love them. These pens are much easier to carry around in pockets and wallets, and they look pretty good, too!
*Note: All pics were taken by my HTC TyTN. Sorry if the quality is bad, but its two megapixels.

Ingredients:

A Bic brand ballpoint pen
Scotch or comparable tape
Scissors or an X-acto knife
Paper or some other protector for your desk*

*Note: I am not responsible for any ink spills on your table or computer desk. Nor am I responsible for any damages and deaths that may occur while using sharp objects.

Disassemble the pen as shown in the pictures. I used my X-acto to pry it open, and then pulled the guts out with my bare hands.

Cut the pen tube with your scissors (or X-acto knife, in my case) and trim it up.
Refer to pictures if you need help or guidance. (NOTE: I cut right before the USA part, so it would look nice and clean.)

Next, cut the ink cartridge. Do this fast (scissors may get inky) and tape it up as shown in the pictures. Taping the other end (which you will discard) is necessary if you want to keep from ink getting all over your garbage can.

Place your ink cartridge in the tube. I used my pocketknife to tap it SLOWLY, please take care not to pop the ballpoint out !

The pen is DONE!!!

Have a go and try your pen out! Comment if you liked it!