Lego Claw

One day when I was building with Lego I came across a good design for a claw. I improved it and I came out with this claw. I used to have a 3 hole Lego technic beam at the end of the grabber but I modified it so it could hold on to things better.

This is the mechanical part that will pull the two claws together.

These are the two claw halves and the part that will hold the rubber band.

This step is attaching the part that will pull the claws together and putting on the rubber band.

This step is the handle. Pay attention to where the black pins are put.

This part is the part that you will pull to make the claws close.