Legion Go D-Pad Replacement
by aplaceforjunktogo in Circuits > Gadgets
2630 Views, 1 Favorites, 0 Comments
Legion Go D-Pad Replacement
![8.jpg](/proxy/?url=https://content.instructables.com/FEU/70CK/LQCCUFZQ/FEU70CKLQCCUFZQ.jpg&filename=8.jpg)
Download and Print D-Pad replacement.
Supplies
https://www.thingiverse.com/thing:6364915
6mm X 2mm rare earth magnet
X-Box elite metal D-Pad Hat
![1.jpg](/proxy/?url=https://content.instructables.com/FOA/F4JY/LQCCUG98/FOAF4JYLQCCUG98.jpg&filename=1.jpg)
Remove 4 screws. These are screwed into plastic, and made of cheap metal. Use firm pressure, and go slow.
![2.jpg](/proxy/?url=https://content.instructables.com/FA0/EGUT/LQCCUG9F/FA0EGUTLQCCUG9F.jpg&filename=2.jpg)
Use a pry tool. This is an easy spot for entry.
![3.jpg](/proxy/?url=https://content.instructables.com/FA1/OBWD/LQCCUGA0/FA1OBWDLQCCUGA0.jpg&filename=3.jpg)
4 more screws and a rumble pack connector. Again into plastic, be judicious. R2 will come loose.
![4.jpg](/proxy/?url=https://content.instructables.com/FF2/RA2Z/LQCCUGAY/FF2RA2ZLQCCUGAY.jpg&filename=4.jpg)
Pry here and pull the RB off.
![5.jpg](/proxy/?url=https://content.instructables.com/FI8/B2C2/LQCCUGBX/FI8B2C2LQCCUGBX.jpg&filename=5.jpg)
Remove PCB. CAUTION: Ribbon cable is TINY. When you remove the PCB, unfold it like you were opening the cover of a book. You can leave it attached or flip the clasp on the PCB to remove it. I removed it the first time, but it was painful getting it in and closed. Remove the controller release button.
![6.jpg](/proxy/?url=https://content.instructables.com/FF5/8IE4/LQCCUGD0/FF58IE4LQCCUGD0.jpg&filename=6.jpg)
drop in 3D Printed D-Pad replacement. loosely install RB.
![7.jpg](/proxy/?url=https://content.instructables.com/F8D/OQ78/LQCCUGDT/F8DOQ78LQCCUGDT.jpg&filename=7.jpg)
Goes back together much the same way it came apart. If you have gotten this far, you can figure it out.