Leather Fidget Spinner

Simple fidget spinner from leather, no special tools needed.

Trace and make sure to mark center points before cutting.

Tape face of the skin to protect it from glue, then put thick layer of glue and clamp it (make sure it don't slip)

Using previously marked center point place your bearing in exact center and draw outline, then cut it.

Draw inner circle of bearing on leather and cut it out, you need 2 of these, then glue them together and clamp between 2 pieces of scrap leather.

Draw outline of the nut on each side, cut it out and test fit the nuts.

Dye it and let it dry then give it one coat of varnish.

Sand the sides then glue it inside bearing.Cut out couple of slightly bigger circles and glue them as shown on picture.

Insert everything on its place and have fun:D (gluing is not necessary if it have snug fit)