Laser Cut Touchless Door Openers

The application below is two in one; a hand and finger hook to open doors and drawers without touching them. Use the file provided to create your own touchless door opener to keep your hands germ-free.

• CO2 laser cutter (We used a Trotec Speedy 360 80W with a 2" lens)
• 1/4" (6mm) acrylic (available at link below)
• Laser masking tape or painters tape (this is to seal off you laser bed for optimal exhaust)

www.engraving-supplies.com

Position a 1/4" (6mm) piece of acrylic into the laser machine and cut the material using one or both of the files provided.

Laser Parameters for Cutting*

• Power (%): 100
• Speed (%): 0.6
• ppi/Hz: 5000
• Passes:1
• Air Assist: Yes
• Z-Offset: None

Laser Parameters for Engraving*

• Power (%): 50
• Speed (%): 100
• ppi/Hz: 1000
• Passes: 1
• Air Assist: Yes
• Z-Offset: None

*Use these parameters as a guide but make sure you adjust your settings if you have a different laser system or a different wattage.

Once processing is completed, wipe any excess dust or debris from the surface of the acrylic and remove from the laser system. Attach to a retractable, clip-on badge holder for quick and easy access.