Laptop Light

by dphysics in Circuits > LEDs

1358 Views, 3 Favorites, 0 Comments

Laptop Light

Photo 2013-05-10 10.10.24 AM.jpg
Photo on 5-13-13 at 10.54 AM #2.jpg
Photo on 5-13-13 at 10.54 AM.jpg
Photo on 5-13-13 at 10.57 AM.jpg

Step 1: Drill Holes

Photo 2013-05-10 10.10.16 AM.jpg
Drill 4 holes in the pipe insulation for the LEDs and then cut out a rectangle for the switch. Each hole should be evenly spaced out, we did about 1.5" between each LED. 

Step 3: Cut Out Rectangular Hole for the Switch.

To cut out the rectangular hole, make sure to use sharp scissors. Also try to cut the hole a little smaller than the switch itself for the switch to fit snug inside.

Step 2: Making a Circuit

Photo on 5-13-13 at 11.25 AM.jpg
The Circuit is a Series Circuit. 

Step 4: Connect Each of the 4 LEDs With Copper Wire and Solder

Photo 2013-05-10 10.10.21 AM.jpg

Step 5: Connect 12v Battery to the LEDs Using the Copper Wire

Step 6: Flip the Switch to Turn on and Enjoy.

Photo on 5-13-13 at 10.57 AM.jpg

Materials

Pipe Insulation (any length you want)
LEDs
12v Battery
Copper Wire
Paper Clips
Switch