LED Chaser Improve!

This LED Chaser is a project created using Arduino Leonardo based on the project that I find on this website (Instructables), made by Shoeb ALI. I improved this project with a little bit of changes and made this better.

Original work website:

https://www.instructables.com/Arduino-LED-Chaser-W...

Improves:

To improve this project, I add a button that can turn on the LED. Also, I give this project a decoration that could make it look better.

1. Breadboard *1

2. Button *1

3. LED*9 (Red*3/Green*3/Blue*3)

4. Wires*40

5. 220 ohm resister

6. Arduino board *1

Decorrection

1. Box

2. Wapping Paper

Connect 9 LEDs with RGB pattern (RGB,RGB,RGB). Add the button and test if the LED lighting pattern still works. After that, add some longer wires for letting it can easier putting in holes that would make later.

https://create.arduino.cc/editor/jenniferko/9a2b6a...

For decoration, put the whole product inside a box that could fit, after that make holes to fit the buttons and LED lights to show up. Add pieces of wrapping paper and make the box have the better looking. After all the decoration then it's finished.