Knex Table Top Music Stand.
This is my one PAGE sheet music holder for on a table. it is very simple, and I give credit to
I am canadian.
(because this was part of his v2 mini crossbow, (I start to make it, then relized that there was no way i had enough pieces ( i got very angry)))
I am canadian.
(because this was part of his v2 mini crossbow, (I start to make it, then relized that there was no way i had enough pieces ( i got very angry)))
Vertical Bit
This is how to build the vertical bit.
you need:
8 purple connectors
3 yellow connectors
2 yellow rods
2 blue rods
8 green rods
1 blue connector
2 white rods.
you need:
8 purple connectors
3 yellow connectors
2 yellow rods
2 blue rods
8 green rods
1 blue connector
2 white rods.
Music Holding Part
In this step you will receive basic training on how to build the part that has the bottom of the music on it.
There is a blue rod under the red one.
you need:
3 blue rods
6 white rods
2 green rods
2 Grey connectors and
1 red rod
There is a blue rod under the red one.
you need:
3 blue rods
6 white rods
2 green rods
2 Grey connectors and
1 red rod
The Making Of
In this step I will teach you the ancient art of assembling the music stand.
You are now ready to proceed to the next level of training,
The super ultra mega knex music stand
you need:
1 green rod
You are now ready to proceed to the next level of training,
The super ultra mega knex music stand
you need:
1 green rod