K'nex Whiteboard Stand

The whiteboard stand is made of hundreds of parts.

Not liking the online? Download my PDF version for free.

http://www.mediafire.com/download/ywi1tqthp9kyzoc/...

Here are the parts:

PARTS COUNT: Rods: - White 1 5/6 in: 4 - Blue 2 1/4 in: 12 - Yellow 3 7/16 in: 72 - Red 5 1/8 in: 67 - Light Grey 7 1/2 in: 46 - Black 7 1/2 in: 1 Total Standard Rods: 202 Connectors: - Red Connector: 6 - Yellow Connector: 19 - Blue Connector: 37 - Dark Gray Connector: 54 - White Connector:1 - Orange (or Brown) Connector: 14 Total Standard Connectors: 131 Miscellaneous: - Whiteboard (the board dudes size, not included in set) - Markers (dry erase, not included) - Booklamp or electrical lamp (not included) FINAL TOTAL PARTS: 333 pieces

CAUTION! I advise you not to use micro parts for this project. The reason is that when the whiteboard placed on a micro parts, it puts too much pressure and the structure would break. So do not use micro parts.

Build the left part of the tower using the images below. Once completed to parts to the lower left, stack the second part on top of the lower left base.

Build the second half of the left tower, then attach to the rest of the left tower.

PART 1:

Build the right tower base of the tower.

finish the tower using the images above.

Attach the connectors sticking out on the sides of the left to the appropriate areas on the right of the towers.

Create the pouch by using the "Ball Machine" method to create the base.

Attach the rack to the back of the base as required.

Attach the Board Dudes whiteboard onto the stand.

YOU ARE ALMOST DONE!

If you have any NEON markers at your house, use them.

Make a smaller rack to attach to the base as of making it with four yellow connectors, two blue rods, and two yellow rods. Insert two NEON markers.

Find the yellow rods sticking out above the base parallel to the track, and connect the small rack to the base as shown.

This is it! You have used at least 333 parts of KNEX to build this!