Knex Raiser Lift

This is the Knex Raiser lift not to be confused with the knex razor lift (Not that there is such thing).

Video: http://www.youtube.com/watch?v=I-WB3c2Y4RA

Base

Here's the base.

Really Easy Step

Make this!!

Ball Holder

This part holds the ball.

Putting on the Ball Holder

Just slide it on!

Exit Track Bit 1

This part pushes the ball off.

Adding Exit Track Bit1

Just put it there!!

Next Layer Part1

Make these or make one of them and repeat four times.

Next Layer Part2

Now stick them on top.

The Crankshaft

This will go in the gap.

Adding the Crankshaft

Here's where to put it.

Really Really Easy Step

Easier than step 2 :-)

Put this 'extended rod' on the crankshaft and ball holder.

Adding in the Motor

Put the motor on the Yellow rod like so:

The Top

This part is somewhere between "for show" and "adjusting the pieces"

Putting on the Top

On top, where else?

Enterence Track

This part is closer to the bottom

Putting on the Enterence Track

Near the front

Finishing the Enterence Track

Three small pieces

Putting It All Together and Finished!