Nerf Reflex

This Instructable will show you how to make a working Knex Nerf Reflex replica.

You will need, 28 green rods, 1 twist tie, 3 rubber bands, 15 small separators, 20 caps, 8 large separators, 9 red corners, 7 blue rods, 12 orange connectors, 1 white connector, one green connector, 4 purple ends, 12 yellow connectors, 2 orange bendy rods, 2 red rods, a piece of tape, and (a grey rod-optional).

Build the two sides, then add rods, separators, and caps to one side.

Make these rods and add them where shown.

Make the trigger. Add tape where shown. You will definitely need it... Next, add the trigger on.

Make this piece and add it on.

Add the other side, separators, and caps as shown.

Build this rod and add it to the trigger.

Add a tie to the front of the barrel to keep it from swinging.

In Nerf, it's called a plunger. Build it, and add it to the gun through the holes in the orange connectors.

Add the rubber bands.

To prime, hold the trigger and pull back the plunger. Add a blue rod to the front of the barrel.

For more power, you can replace the red rod.with a grey rod. That's why it was optional.

You now have a Nerf Reflex! Enjoy!