K'Nex Superion Combiner Transformer

Found some free time this summer, and so decided to make another transformer, suggested by stoudcorb. This one's just a combiner, no individual robot modes for the planes to keep the models small and simple. Each plane has its own nose for some individuality, plus some wing and tail differences to help.

8-Way Connectors - 3

7-Way 3D Connectors - 6

5-Way Connectors - 93

4-Way 3D Connectors - 10

4-Way Connectors - 23

3-Way Connectors - 31

2-Way Straight Connectors - 21

2-Way V-Connectors - 36

Female Hinge Clips - 3

Male Hinge Clips - 1

Ball Clips - 5

Socket Clips - 4

1-Way Clips w/ hole - 4

Metallic Blue Clips - 12

Orange 3D Clips - 4

Y-Clips - 45

16 mm Rods - 179

32 mm Rods - 90

54 mm Rods - 10

86 mm Rods - 1

Thin Spacers - 6

Torso of Superion.

Arms of Superion. Just noticed that the wings on the instructional plane are asymmetric, feel free to build symmetric.

Last picture to check for left-right accuracy (if that's important to you)

Legs of Superion.

Standing is of course iffy, it does stand but you're probably better off leaning it against a wall.

Thanks for checking it out!