Jeep Wrangler Paracord Handles

I have a Jeep Wrangler and have been wanting handles made for awhile now. I decided to make some on my own. These handles are simple and made out of 3 materials and can be made in minutes. These are the perfect alternative to high dollar handles, My total cost for the materials came to twenty-two dollars.

For this DIY you will need few supplies:

Scissors

A lighter/heat source

Velcro

Paracord (at least two cords)

Breakaway Buckles

Side note: All supplies may be found at hobby lobby

Run cords through the buckle and secure them as shown.

Pull left black cord under middle cords and over the pink, then pink over middle cords and under left black cord, then pull tightly.

Continue the pattern of braiding until your desired length, ideally 8 inches.

Cut the remainder of the cords after you have reached the desired length.

Flip over the paracord handle and make the same pattern tie on the backside.

In order to secure the cords from coming apart, use the lighter to singe the ends of the cords.

Measure your velcro out to approximately 8 Inches and cut it.

Connect the velcro to each other matching up only a few inches, then slide them through the buckle and connect at desired diameter.

After the straps have been attached your Jeep Wrangler Paracord Handles are complete!

Slide the single strap around your roll bar and fasten the velcro together at your desired width!