Irrigation System V2.0

Electronics hobbyy always intersted in irrigration systems, because they are so important in the rationalization of water consumption, during the water sources are going to be not available for all. so in this tutorial i will show you all the steps to make the second version of the irrigation controller with more channels, and options.

Where in the step one we will get on PCB manufacturing , than soldering and finaly programing + testing.

Sometimes its good to make your PCB in china , but this its not the case, beacuse alot of reasons, so lets make it using old methodes , where i print the shematic in pic paper, then transfer it to the copper using iron, and finally deeped it in the chemical product.

Electronicshobbyy is a fan of soldering so be sure that you will enjoy watching my soldering in the video below :D.

The diffrence between this two versions its so large, talking about the internal system, hardware and software, where in V1.0 i have used the Atmega328 microcontroller + an encoder to control the menu , but its not the case for the V2.0 , i have switched to the STM32 microcontroller and buttons for the menu.

To get the code + pcb please DM in my instagram @electronics_hobbyy

and dont forget to subscribe my channel x)

https://www.instagram.com/electronics_hobbyy/