Introduction for Obstacle Avoiding Robot

Hello There!

i have mentioned all the steps of creating your OWN obstacle avoiding robot in the 2 videos given.
and also if you dont have any components, DO NOT WORRY. i did all of this in a website called tinkercad.com.
this website has all sorts of stuff for robotics and is perfect for beginners. You can model, and also build a circuit for your robot.
I didnt talk about modelling in my videos but instead focused on the actual electronics the robot requires.

I have shared all the components required for the OBSTACLE AVOIDING ROBOT.
>Arduino - 1
>Breadboard(ANY SIZE IS FINE, BUT I USED THE SMALL ONE) - 1
>DC Gearmotor - 1
>Sensor - 1

After fixing all the components and jumper wires in the same position. You will get this.
but getting this is not enough, you will have to write the code.
i have also put up the code, use it and make your first ever robot! :)

Given above is the code which you can use in tinkercad.com to officially finish creating your first obstacle avoiding robot.